Epoxy Coating Palm Beach - Epoxy Coatings Deliver Quality Flooring Solutions To Some Of The Toughest Floor Problems
- If you only want to apply epoxy on the floor, then stick the plastic sheeting on the wall close to the floor. Then sweep the entire area and remove all dirt and dust.
(prHWY.com) December 6, 2012 - Florida, FL -- Florida, Dec 06, 2012 - If you only want to apply epoxy on the floor, then stick the plastic sheeting on the wall close to the floor. Then sweep the entire area and remove all dirt and dust. Do this thoroughly, and do not forget to also clean out the corners and seams.

After we have made sure that the garage floor is dust-free, it's time to etch the floor. We mix an etching solution with water in a watering can. Follow the manufacturer's instructions on the etching solution, and don't forget to wear protective gloves, rubber boots, and safety glasses.

Garage Floor Coating Broward - We first wet the floor before pouring the etching solution in the farthest corner of the garage floor. Pour the solution only on a 10x10 ft square area. From this area, we scrub first in one direction and then go over it again in a perpendicular direction. Use a bristle broom in scrubbing the floor. Continue this process in small sections until you've covered the whole floor. Then rinse the area thoroughly and let it dry for at least 4 hours.

Etching is applicable to new or bare floors. There is no need to etch a painted floor. You only need to scuff the paint with a floor maintainer and a light-sanding pad. Then sweep and scrub the floor with a bristle broom and an all-purpose cleaner. Rinse the floor and then let it dry for 4 hours or more.

Stir the epoxy paint while you slowly put in the hardener. The hardener should be mixed well into the paint. Stir carefully, and then cover the mixture and set it aside for 30 minutes. Keep it away from the sun while we wait as the chemicals in the mixture react with one another.

This has to be done quickly. The epoxy formula must be applied within 2 hours for it to work properly. In applying the epoxy coating, first paint a border around the area to be covered. Paint the epoxy into the seams and corners, too, before finally applying it to the garage floor. Use a 3-inch paintbrush to make the border and cover the seams and corners.


About the Author:

Epoxy Coating Palm Beach - CONCRETE FLOOR SPECIALISTS has more than 15 years of extensive field knowledge and innovation in seamless Commercial Industrial flooring systems and polymer components: Epoxies, Urethanes, Mortars and Methylmethacrylate (MMA)

Contact Details

Concrete Floor Specialists
20533 Biscayne Blvd #433
Aventura, Florida 33180

###